Introduction

This guide will instruct you how to install the flash on your camera.

  1. NEVGWMkZBAxyLAXV
    • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

  2. TgWY24VK461rRb2P
    TgWY24VK461rRb2P
    YsYNhMPUVt1pAeVx
    • Using your finger, peel back the textured grip so the components are separated.

  3. WUtpnyKjcAyBnPcp
    WUtpnyKjcAyBnPcp
    CnPNxUvtCpknxsRA
    bDCxHGA3UTIArKuB
    • Using the flat end of a spudger, loosen the connection between the front panel and the device.

    • Remove the front panel using your hands.

  4. QtTgmajULeawTqNX
    QtTgmajULeawTqNX
    W1IDbWy52lWWcxJl
    • Pop the flash up with your thumb

  5. vY2kq1HZLRllQO1f
    • Unscrew the two screws on the front of the flash near the bulb cover.

  6. B2eCKKWOJRAxJd6R
    B2eCKKWOJRAxJd6R
    C2lx6OqjV5IGGJ3Q
    q6WFUXSCoaIFAJRF
    • Close the flash.

    • Lift the flash cover off.

  7. EIlkstv4gfvp5Vxn
    EIlkstv4gfvp5Vxn
    ZDcNnLieRxoVDdpQ
    • Pull off yellow capacitor from flash wiring.

  8. kH6UFtpYacioIL2P
    • Remove white cocking with a razor blade, and then unsolder connection.

  9. K1x2x5i1oinGsREZ
    K1x2x5i1oinGsREZ
    nc13MdukdWTTXLtc
    • Remove the flash cover to access the flash bulb.

    • After wires are unsoldered, slide flash bulb out from housing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Zach

Member since: 04/04/12

43 Reputation

0 comments