Introduction
We are removing the old light filter foam and replacing it with new foam in your Canon AE-1. This will help keep light out of the inner case so that it doesn't wreck the film.
-
-
Open the film compartment by pulling on the release pin.
-
Use a 3mm slot screw driver to scrape old light filter foam cleanly off.
-
Then use Isopropyl Alcohol to assist in removing the old light filter foam.
-
-
-
Cut the new light filter foam to size so it can fit in the slot.
-
Place the sticky side of the new strip of light filter foam over old foams location.
-
Conclusion
To reassemble your device, follow these instructions.
