Bottom Plate Removal

Written By: Sam Gustafson
  • Comments: 0
Bottom Plate Removal

Difficulty

Easy

Steps

11

Time Required

5 minutes

Introduction

  1. lgs2BFmwctNUvEEY

    • Push down on the screw to depress the spring loaded hinge and release the door.

  2. xqMOa4QfTrEMSjLQ

    • Remove six 5.3 mm #00 screws.

    • Remove one 3.4 mm #00 screw.

    • The short screw has a machine thread and screws into the plate underneath. The rest screw into the plastic body.

  3. JBNm1gvrrVIsOnvC

    • Remove three 5.3 mm #00 screws (the bottom-most screw is not always present).

    • Remove one 7.3 mm #00 screw.

    • Remove the remote trigger cover.

  4. kaurbKcGc3sICMvp
    kaurbKcGc3sICMvp
    qAMWaUYPEdKSqKBQ

    • Remove one 3.4 mm #00 screw.

    • Remove two 5.3 mm #00 screw.

    • Gently lift up on the flash housing to help remove the cover if necessary.

  5. XTT2gETZspMWvdLW

    • Remove two 3.9 mm #00 screws.

  6. 3my2vQuEkTFMiy1K

    • Slide the eye cup up and off to access the screws underneath.

  7. e53TOwaDpAgeyAD6
    e53TOwaDpAgeyAD6
    OJJ5WDhEjPdLrFAa
    XYapgMENQtcSAZZH

    • Remove two 5.3 mm #00 screws by the eyepiece.

    • Remove one 6.8 mm #00 screw in the battery compartment.

    • Remove one 7.0 mm #00 screw near the take up spool.

  8. htpX4AygbXbvTyuw

    • Lift the cover so it is just free of the body. It is still attached by several wires.

  9. PKWDKajPwI1IsKvN
    PKWDKajPwI1IsKvN
    UBHqaljejtUWVWKI

    • Remove two 3.4 mm #00 screws. Remove the plate holding the contacts in place.

    • Peel tape from the plate. Leave the tape attached to the flex circuit.

    • Remove the flex circuits from their retaining studs.

  10. uykjwxRmjoOdsLBL
    uykjwxRmjoOdsLBL
    IQuZFa2eCtcwCXYD

    • Remove one 3.3 mm #0 countersunk screw.

    • Remove one 3.9 mm #0 shoulder screw.

    • Remove four 3.3 mm #00 screws.

    • Pull a little slack through the housing on this flex cable.

    • Pop the plate off its posts, rotate slightly clockwise and pull gently through the loosened flex cable.

    • To the camera tech that left me a happy little note...I see you.

  11. vKTVsERkAFutSugF
    vKTVsERkAFutSugF
    HncNyUpLEDnLUcwx

    • It's best to remove these parts now so they don't fall out later on in the repair.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sam Gustafson

Member since: 02/09/22

3233 Reputation

0 comments