Introduction
This guide will take you through the process of replacing the powerhead assembly on the Black and Decker BV2500 Type 4. The powerhead assembly contains all the internal components and you can buy it separately. This will save you from buying costly individual parts.
Tools
Parts
-
-
Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).
-
-
-
Using your hands, remove the blower tube and clamshell.
-
To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.
-
-
-
The powerhead assembly is the entire orange part of the device.
-
Replace it with a new powerhead assembly.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
add action shots
Rhys -
ATTENTION : As comments say, BV2500 DOESN'T have screws to remove the nose. You interchange blower and sucker by pressing a release button.
You DON'T need to open the motor housing.
Just use a socket wrench CLOCKWISE to release the plastic nut in the center of the fan
Simeon -