Black and Decker BV2500 Type 4 Power Cord Replacement

Written By: Angelica Chow
  • Comments: 3
Black and Decker BV2500 Type 4 Power Cord Replacement

Difficulty

Easy

Steps

6

Time Required

15 - 20 minutes

Introduction

This guide will take you through the process of replacing the power cord on the Black and Decker BV2500 Type 4. Without a power cord that works, the device will not turn on.

  1. AKrAQuSrRI5FYXRo

    • Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).

    add action shots

    Rhys -

    ATTENTION : As comments say, BV2500 DOESN'T have screws to remove the nose. You interchange blower and sucker by pressing a release button.

    You DON'T need to open the motor housing.

    Just use a socket wrench CLOCKWISE to release the plastic nut in the center of the fan

    Simeon -

  2. 2RAtSn4igdssAIIQ
    2RAtSn4igdssAIIQ
    vTqTYmxkIh1JtGdi

    • Using your hands, remove the blower tube and clamshell.

    • To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.

  3. J3ieEjiv3vmGUbhO
    J3ieEjiv3vmGUbhO
    Kg4EZcJdEpYjfIdP

    • Using a Phillips #2 screwdriver, remove the ten 20 mm screws in the orange casing.

    • Use your hands to lift off the side of the orange casing with the screws facing you.

  4. 6GxIER5JD1qEfS46
    6GxIER5JD1qEfS46
    XRJbypEuI2HGEI4b

    • Locate the switch.

    • Remove the 2 black and white wires with blue casings from the switch.

    • Using your hands, push in the sides of the switch and slide out the wires.

  5. 1mwRAMnwURmBYIPP

    • Remove the two 20 mm Phillips #2 screws that are holding in the power cord (located at the bottom of the leaf hog).

  6. AVBFTW4bfIdGyFVr
    AVBFTW4bfIdGyFVr
    OHgGKdZGdtaNDssd
    CmJQTV6AAZy4MABX

    • Slide the power cord support off the power cord in the direction of the leads.

    • Use your hands to pull the power cord out of the device with the lead end coming out last.

    a better picture of the removal of the power cord would be good. It's hard to see against the background of the internal components.

    Rhys -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Angelica Chow

Member since: 25/01/14

409 Reputation

0 comments