Introduction
You will need to have completed the prerequisite guides prior to this guide in order to execute it.
Tools
-
-
Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.
-
-
-
Remove the following screws that secure the top and bottom halves of the base.
-
One 1/4 Phillips screw
-
One TA-20 screw
-
-
-
Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.
-
-
-
Remove the four screws located on the circuit board.
-
Two are on the left side.
-
Two are on the right side.
-
-
-
Remove the following soldered connections with a soldering iron:
-
Motor wires
-
Power cord wires
-
-
-
Once the circuit board has been freed from its screws it can be moved out of the way to gain access to the buttons.
-
A single screw must be removed from the top as shown.
-
-
-
Push firmly from the outside of the blender on the face of the buttons to pop it out of its locked position.
-
To reassemble your device, follow these instructions in reverse order.