Black and Decker 12" Grass Hog Automatic Feed String Trimmer GH400 Line Replacement

Written By: Camille Guzman

Comments: 0

Black and Decker 12" Grass Hog Automatic Feed String Trimmer GH400 Line Replacement

Difficulty

Moderate

Steps

Time Required

10 - 20 minutes

Introduction

The line of a weed whacker will often shorten and break due to use over time. Follow this guide to change the line on your Black and Decker 12-inch Grass Hog Automatic Feed String Trimmer (Model No.GH400).

Before beginning this repair, make sure your weed whacker is off and not connected to power before trying to replace the line. You'll need 1.7mm of line for the trimmer and a pair of scissors.

Tools

Scissors

Parts

Black and Decker Trimmer Line

Step 1

To prepare a new line for your weed whacker, use your utility scissors and cut a piece of line between 30 cm and 50 cm long.

Step 2

Press the buttons on the opposite sides of the trimmer cover and lift it off the head of the trimmer.

Step 3

Remove the spool from the trimmer head.
Be careful when removing the spool as the line is still being fed through the access hole.

Step 4

Remove any remaining pieces of old line by sliding it out of the space it sits in.
Insert the new line into the opening.

Step 5

Wrap your line around the spool and make sure you leave 10 cm of the line loose.
There are arrows on the spool indicating which direction to wrap the line.