Introduction

These are the first steps to taking apart the device.

  1. SGLn4yl5FcUkrPry
    SGLn4yl5FcUkrPry
    YKYWbvZIJlBFIhuk
    • Remove the five 30mm Phillips #0 screws on the bottom of the camera.

  2. 4Q4wScChpAdGOFVv
    • Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.

    • Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

  3. gpStOUcsTtOBoabC
    • It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jerry Hadjah

Member since: 04/03/16

525 Reputation

0 comments