Barreto Tillers E1320HTRLR 2016 Tine Replacement

Written By: Carsten Frauenheim
  • Comments: 0
Barreto Tillers E1320HTRLR 2016 Tine Replacement

Difficulty

Moderate

Steps

9

Time Required

5 minutes - 1 hour

Introduction

This guide shows how to remove and replace the reversible tines on the Barreto Tiller E1320 2016.

Tines should be changed as often as needed. Use Loctite 271 on tine bolt threads to prevent them from loosening.

  1. s2YGUE2hAZBeY2af
    s2YGUE2hAZBeY2af
    ZZcXNQfl6oHSSvcK

    • Before you begin, ensure that the engine is powered down and cool to the touch.

    • Grab the plastic housing at the end of the spark plug wire and pull firmly to disconnect it.

  2. 5XNxZUOMumNRQnZi
    5XNxZUOMumNRQnZi
    PRbKxuQaVOccHEaH

    • Flip the red engine ON/OFF switch to the OFF position.

  3. ELbXP1OZsK5dtsBV
    ELbXP1OZsK5dtsBV
    RrbPTfJWnGLicru3

    • Flip the fuel valve lever to the OFF position.

  4. jOQUT6h4DWhEndhK
    jOQUT6h4DWhEndhK
    pwrPhQvk2RKy5MpD

    • Flip the ignition switch to the OFF position.

    • Ensure the wheel drive control lever is set to the neutral position.

  5. BCLCetXmDSNeQdgl
    BCLCetXmDSNeQdgl
    UJvQ5wEOPFLWwH1F
    TU2RsedTJJWJDUBA

    • Pull the locking pin out and rotate it 90˚ to unlock the right wheel from the hub.

    • Repeat for the left wheel.

  6. iljfxDVpMMRf1PiE

    • Insert wheel chocks underneath each wheel to keep the device stationary during disassembly.

  7. cx2kW6pqP3JolWC3
    cx2kW6pqP3JolWC3
    PcqKGEbEEwxuNQow
    NdyJrSsQrhv54LDQ

    • Use a 5/8 inch socket with an 11/16 inch wrench to loosen the two 5/8 inch bolts and two 11/16 inch nuts securing the tine to the tine shaft.

    • Remove the two tine nuts.

  8. k2mIyW4ZaSnuEhmv
    k2mIyW4ZaSnuEhmv
    jMEoRCX5PkbCVBIK

    • Remove the two bolts holding the tine to the tine shaft.

    • During reassembly, use Loctite 271 on tine bolt threads to prevent them from loosening.

  9. eOUZWqnn3S2ixkds
    eOUZWqnn3S2ixkds
    XBsgLLiMnJhegEKC

    • Remove the tine.

    • Repeat this procedure for each tine you need to replace.

    • Keep track of each tine's orientation.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Carsten Frauenheim

Member since: 10/03/20

110978 Reputation

0 comments