Auto-Feeder Disengagement

Written By: Tarun Thiruma
  • Comments: 0
Auto-Feeder Disengagement

Difficulty

Very easy

Steps

4

Time Required

1 minute

Introduction

Follow this guide to disengage the Auto-Feeder on your Electric Eel Drain Cleaner Z5K12IC75AF so the cable can pass through freely or removed.

  1. P4lTpgLwLEUKfkiB
    P4lTpgLwLEUKfkiB
    LUIHdnyOdY3GBsjd
    6TZvZ2tyGLxDVWvv

    • Unplug your drain cleaner before starting this guide. Because this device may have been used in a septic setting, it should be cleaned and disinfected as much as possible before disassembly.

    • Wear gloves to protect your hands from injury when handling the cable.

    • Ensure the cable is completely retracted into the auto-feeder.

    • Twist the guide spring counter-clockwise to unscrew it from the auto-feeder.

    • Remove the guide spring.

  2. davZ6vQZJJ5grSSh
    davZ6vQZJJ5grSSh
    W5AVMwWZWfQFn3iM
    JZmIOIgDmUOTNPrj

    • Unscrew the tension knob to loosen the tension spring in the top feeder assembly.

  3. ArKKXVtRdPkjnbm1
    ArKKXVtRdPkjnbm1
    fRpgnqxyCKh2nROA
    S3RmJrh2lOBV4pmA

    • Set the feeder adjustment knob in the neutral position, in between the "FWD" and "REV" positions.

  4. BTlRN3kcb6TAgRGg
    BTlRN3kcb6TAgRGg
    vFvdrabPlfStShsT

    • Push the top control finger up as far as possible.

    • This disengages the top feeder assembly and allows the cable to freely move through the feeder. The finger may fall back down on its own and restrict cable movement. If this occurs, simply push the finger back up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tarun Thiruma

Member since: 20/11/19

35226 Reputation

0 comments