Astak Mole Antenna Replacement

Written By: Meshari Alkhelaiwi

Comments: 0

Difficulty

Moderate

Steps

Time Required

10 minutes

Introduction

If you getting a new antenna doesn't work, there might be a problem with the antenna connection inside the camera. This guide will show you how to replace input cable that attaches the antenna to the motherboard.

Tools

Step 1

Remove the four bottom tabs in order to access the bottom screws.

Step 2

Remove all four 14 mm Phillips #1 screws.

Step 3

Remove the SD card.

Step 4

Pry up the motherboard on the four points using a spudger.
The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.

Step 5

Gently pull back the motherboard to expose many of the component's wired connections.

Step 6

Unscrew the antenna in a counter-clockwise rotation.

Step 7

Take out the screw holding the antenna wire with the PH1 size Phillips head bit.
Screw length: 5.3mm

Step 8

Gently pry open the circuit board attached to the antenna wire using a metal spudger.
The regular black nylon spudger should be used whenever possible, especially around sensitive internal components.