Anne Pro 2 Case/Housing Replacement

Written By: Mohamed

Comments: 1

Difficulty

Easy

Steps

Time Required

5 - 15 minutes

Introduction

This guide will show you how to replace the Anne Pro 2 keyboard housing to a Zero-Degree case. This case is better for smaller hands, as well as more ergonomic. You can 3D print this case (link provided in Parts section).

Tools

Parts

Anne Pro 2 Zero-Degree Housing

Step 1

Unplug the Anne Pro 2 Keyboard.
Turn off the Anne Pro 2 Keyboard using the switch on the bottom.

Step 2

Using a keycap remover, remove the the following keycaps: Left Alt, Space Bar, Right Shift, Backslash, Y, H, and the Tab key.

Step 3

Using a Torx T5 bit, remove the five screws from the keyboard.

Step 4

Lift the keyboard slowly from the bottom side.
Do not fully lift the PCB because the battery is still plugged in.

Step 5

Gently unplug the battery connector by wiggling it back and forth.

Step 6

Remove the PCB from the main case.
Gently lower the PCB into the Zero-Degree housing from the top side first.
Firmly press it in once you have lowered it.

Step 7

Screw the five T5 Torx screws back into place.

Step 8

Take the seven keycaps you removed and gently place them in their intended spots on the keyboard.
Firmly press them in, ensuring they are flush with the rest of the keys.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Mohamed

Member since: 16/09/20

205 Reputation

One comment

Anne Pro 2 Software manage the illumination, open the mobile App and choose a pre-programmed scheme or design your own pattern, with a distinct colour for each key if desired. The programmes are easy to use and work on both Mac and PC.

Visit Here- https://www.techtoreview.com/top-picks/a...

Abhinav Pal - 22/02/22