Anker 2.4G Wireless Mouse LED Replacement

Written By: Colin
  • Comments: 0
Anker 2.4G Wireless Mouse LED Replacement

Difficulty

Moderate

Steps

7

Time Required

30 minutes

Introduction

This guide shows how to replace the LED on the Anker 2.4G Wireless Mouse. The mouse will stop working if the LED inside stops working. Instead of throwing out a mostly functioning product, simply replace the LED and get the mouse working again.

  1. NkCtWiPEJWMxYZ22

    • Use a spudger to gently pry off the stickers to reveal the location of the four screws.

  2. NmMgpLAxGA1iFZ6N

    • Remove the four screws to continue.

  3. BZpmvQKoKDTIltXF
    BZpmvQKoKDTIltXF
    gdduPhH3xeeffWIv

    • Pry the center of the mouse apart using a spudger to separate the upper and lower housing of the boards.

  4. vMOJKj6DwnjtMK3R

    • Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.

    • Pull as far up on the wire as possible, but be careful to avoid ripping the wires.

  5. fZvl5o23kIdJZUMb
    fZvl5o23kIdJZUMb
    cGhJHNcMW5UWiRPA

    • Take the upper housing of the mouse and remove the two screws that hold the board in place.

  6. 5XVgFBXRxEcKLiG4

    • Gently remove the circuit board from the mouse.

  7. dc2x6jG4Op1HKpPS

    • To remove the LED, flip the board over and desolder the wires.

    • Replace LED with a new LED and resolder into place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Colin

Member since: 10/02/14

406 Reputation

0 comments