American Sanders EZSand Orbital Sander 07163A 2012 Sandpaper Disc Replacement

Written By: Miles Robinson

Difficulty

Moderate

Steps

Time Required

No estimate

Introduction

Use this guide to replace the hook-and-loop sandpaper disc on a Clarke Floor Sander 07163A 2012.

This guide shows the removal of just one disc, but the procedure for the other two discs is identical.

Before you begin, be sure that the sander is unplugged and powered off.
Carefully tilt the sander back and lay it down on its side, exposing the three sanding pads on the bottom.

This picture doesn’t refer to the white pads between the sanding disk and the base plate.

what is part number for the white pads?

MP481400 Disc, Hook, 6-7/8 O.D is the thin white pad

MP482000 is the sanding disc and pad all in one

Conclusion

To reassemble your device, follow these instructions in reverse order.

Member since: 04/03/19

860 Reputation