Altair WBP-210 Full Disassembly

Written By: raven
  • Comments: 0
Altair WBP-210 Full Disassembly

Difficulty

Easy

Steps

7

Time Required

3 minutes

Introduction

Full disassembly of the Altair WBP-210 (and WBP-212) wireless belt pack.

  1. mluThLqrGZnB3vQh

    • Remove nut on mini-XLR connector.

  2. pyAytXGBUfhnWXaX
    pyAytXGBUfhnWXaX
    bhXnoFLOUQWKU6kv

    • Slide off rubber panels on all four corners.

    • If there are screws underneath, remove those as well.

  3. wECTmEZSX4BYWNsW
    wECTmEZSX4BYWNsW
    hVMJW2rS4cfGyIJj

    • Open the case using a suitable tool to help separate the two halves.

    • Watch out for the ribbon cable.

  4. xOwKWwZcfbON5kT2
    xOwKWwZcfbON5kT2
    ZjCXtLsbFTfhwthB

    • Disconnect the back half of the case.

  5. PlbPTNehLKXMIDCF
    PlbPTNehLKXMIDCF
    iYw6lcXNeDPirFDo

    • There are four screws holding the Auxiliary Board in place.

  6. M2DElHbHvcMqdNRP
    M2DElHbHvcMqdNRP
    N4WfkoPRkgcdqA5i

    • The battery is held in place by a flexible bit of PCB, which can be carefully removed.

  7. 6ChFa6ZjaGbYpWkr
    6ChFa6ZjaGbYpWkr
    lw1aVdCCXFhS42kL

    • The main PCB is held in place by four screws.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

raven

Member since: 02/09/15

1080 Reputation

0 comments