Air Filter Removal

Written By: Craig Lloyd
  • Comments: 0
Air Filter Removal

Difficulty

Moderate

Steps

10

Time Required

5 - 20 minutes

Introduction

This is a pre-requisite only guide for removing the air filter and air box in order to complete other repairs.

  1. P1UYBKTCWwJTKOQr

    • Use your fingers to unscrew and remove the wing nut securing the air filter cover to the air filter elbow.

  2. qAIxaFLEJvLaLMi5
    qAIxaFLEJvLaLMi5
    RAxmLOBFh5QAeeXs

    • Lift up and remove the air filter cover to reveal the air filter.

    • The air filter cover will still be attached to the tiller by a flexible hose. You can push the cover to the side while you continue to work on the tiller, or follow the next two steps to completely remove the cover.

  3. E3g5rgJjlo6URDCI
    E3g5rgJjlo6URDCI
    O2DXEP1sOEY2HayD

    • The next two steps are optional, but they will make it easier to work on the tiller from here on out.

    • Squeeze the metal clip on the inside of the air filter cover and remove it.

  4. awwj62TXZUOClaJB
    awwj62TXZUOClaJB
    gIEhprLPHA2vdfAW

    • Hold onto the air filter hose and pull on the air filter cover to remove it.

  5. AAKoZXBevEt2npI4

    • Use your fingers to unscrew and remove the wing nut securing the air filter to the air filter elbow.

  6. DFDSd34Ae1BMeWnq
    DFDSd34Ae1BMeWnq
    Q5rVOkCCiUj3gYdW

    • Wear gloves or use a rag during this step, as the air filter is coated with oil.

    • Lift the air filter straight up off the elbow, making sure it clears the threaded rod.

  7. vaSMThSXlIKtsSPw

    • Use a 10 mm socket and socket wrench to remove the 25.5 mm-long bolt securing the air filter elbow to the tiller.

  8. MbPxpQVOrxEWgjxi

    • Use a 10 mm socket and socket wrench to remove the two nuts securing the air filter elbow to the carburetor's threaded rods.

  9. SY4ZvWQRmwlQ41El
    SY4ZvWQRmwlQ41El
    BuTcthOv2SKITVJq
    ZKkBUqkuFIvxBgls

    • Use a pair of snap ring pliers to loosen the spring hose clamp on the breather tube, pulling it out 2-3 cm so it's not clamping onto the end of the tube.

  10. K1yHLZr4UHiXrKKf
    K1yHLZr4UHiXrKKf
    II5eVlguGvnOBYUS

    • Pull the air filter elbow straight off, making sure it clears the carburetor's threaded rods.

    • As you remove the elbow, you may need to use your other hand to remove the breather tube from the engine's valve cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Craig Lloyd

Member since: 10/02/16

35240 Reputation

0 comments