Introduction

  1. QLgo3KS6qZDl2yK5
    QLgo3KS6qZDl2yK5
    N3OdjLvpYTl2D4DF
    • First begin by flipping the laptop on its back and having the back cover face you directly.

    • Then unscrew the ten Phillips head screws that hold down the back cover using a Phillips #0 Screw Driver.  

  2. wJAFyVEMpcPAPGAj
    • Using a plastic spudger, open the back cover and remove it from the laptop.

  3. JEZTHsDZfENdFhXw
    JEZTHsDZfENdFhXw
    DTlAecE2R3oT1SI4
    aBJMTVGdkH1H4sPm
    • look for the battery in the bottom half of the computer

    • Once you have found the battery, look for the screws that secure the battery, in the upper left and right corners.

  4. WLNNwRQCWVAeOEMC
    WLNNwRQCWVAeOEMC
    sJsnlR3B3KmIqgVI
    KXHQgQCsbBjBPJKv
    • Begin by unscrewing the two Phillips head screws that hold down the battery using a J1 sized screwdriver.

    • Finally remove the battery from the laptop.

  5. BCSSlKNTZ4BedGVk
    BCSSlKNTZ4BedGVk
    3HANnYDVHxyagL1R
    UT5pyFBFavCUXWDA
    • Begin by locating the speakers.

    • Once you have found where the speakers are, direct your attention to the speaker to the left of the mouse pad.

    • Grab your tweezers and begin disconnecting the wire that connects the speakers to the circuit board on the upper left corner.

  6. OfWLEFYTDcUZXb6h
    OfWLEFYTDcUZXb6h
    buChqKBlaIbgCYUe
    eDpEBYn4oYZcWZbR
    • Locate where the mouse pad would be, this should be relatively easy as it will be right in between the two speakers.

    • Start peeling off the black tape that is covering the speaker wires.

    • Fold back the cables that are on top of the wires for easy removal of the speakers.

  7. LLiAKmDlvIJNpnwR
    LLiAKmDlvIJNpnwR
    A5cwXqXAE6CGhxfu
    fKwKtYV6X3clJG3O
    • Direct your attention back to the speaker that you were first working with in step 5.

    • Start by pulling up on the speaker, it should simply come right out.

    • Repeat this for the right speaker.

    • Once the two speakers are removed, unhook the wires from any clips that may be holding it to the computer.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kyle

Member since: 25/09/17

125 Reputation

0 comments