ATT EL52300 Speaker Replacement

Written By: Eddie Barnes
  • Comments: 0
ATT EL52300 Speaker Replacement

Difficulty

Difficult

Steps

6

Time Required

30 minutes

Introduction

This guide will show you how to replace the speaker for your EL52300 handset. This guide involves direct contact with the motherboard, as well as use of a soldering tool. Any safety precautions present in the motherboard replacement guide for this device, or the soldering guide for this website must be followed.

  1. EIiavp3TaJis1413
    EIiavp3TaJis1413
    gg3sZLyYTPFnsMPE

    • Find the bump where the battery cover meets the phone. Put your thumb here, and push and slide the cover down.

  2. 6JJMoO5tOhIPNl53

    • Unplug the battery by squeezing your hands on the small white plug and lifting it up.

    • Do not pull on the wire itself because you might damage the wire!

    • The battery is now detached and ready to be removed by lifting it out.

  3. VsgucWVxEHAXTBSL
    VsgucWVxEHAXTBSL
    rrbqBgbX1FMKs5P3

    • Remove the two 3.75 mm screws with a PH1 screwdriver.

  4. aLDL2tSD4D6WGhNa
    aLDL2tSD4D6WGhNa
    W2ESVfwhcbVRCrrV

    • Use a plastic opening tool to remove the handset case.

    • Be careful to not lift the case too far as the ringer cable is attached to the case.

  5. eSBRnZNe1eQBhVFG
    eSBRnZNe1eQBhVFG
    rOTeQ2C6Ffmyxl5V

    • Remove the two 3.65 mm screws on the motherboard with a PH1 screwdriver.

    • Use an anti-static wrist strap to prevent damage to the motherboard.

  6. 36ChLOHgffreNawL
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Eddie Barnes

Member since: 10/02/16

323 Reputation

0 comments