ASUS ZenWatch Charging Cradle Circuit board Replacement

Written By: Wayne McClure
  • Comments: 1
ASUS ZenWatch Charging Cradle Circuit board Replacement

Difficulty

Easy

Steps

2

Time Required

15 minutes

Introduction

Replacing the circuit in the charging cradle

  1. PjHGTBDmgJSLTa5c
    PjHGTBDmgJSLTa5c
    IeFtggL4iC2IWpUT
    aSUFUZHAwlvBKspP

    • Using a metal spudger gently pry the plastic outer case apart

    • Pry open a little bit on each side before trying to open fully

  2. cXoAPUjSqUcLZAQy
    cXoAPUjSqUcLZAQy
    wujTyJNCGXFrUhY5
    VYjVJUVQuJwFIkLV

    • Use the PH0 sized Phillips screwdriver to remove the three screws (2mm) holding the board to the cradle.

    • Gently pry up with your hands to pull the board off.

    • Don't grab directly on the USB port as you may loosen or bust the connections.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Wayne McClure

Member since: 10/02/16

961 Reputation

One comment

If you had listed what components were on the board or at least taken a picture of the other side of the board, I might have given you some points.

Nate Fansler -