1998-2002 Honda Accord Distributor Cap Replacement

Written By: Miroslav Djuric

Comments: 5

1998-2002 Honda Accord Distributor Cap Replacement

Difficulty

Moderate

Steps

Time Required

No estimate

Introduction

Use this guide to replace your 4-cylinder Honda Accord's distributor cap. This specific guide was created for a non-VTEC F23A5 engine, but other 4-cylinder Honda engines will be similar enough to follow the same basic steps

Tools

Parts

Honda F23A5 Distributor Cap

Step 1

Before disconnecting the spark plug wires, be sure to trace their orientation from the individual cylinders back to the distributor cap.
The cylinders are ordered from left to right when viewing the engine from the front of the car, with cylinder #1 being closest to the passenger side of the vehicle.
Mark the order of the spark plug wires on the new distributor cap with a silver sharpie marker -- it will make reinstallation much easier.

There is a problem with the order, the first cylinder is on the right not on the left, always next to the timing pulley, the numbering is opposite.

But following your reflection it is and all the same good

Denis bache -

Step 2

Disconnect the four spark plug wires from the distributor cap by pulling their connectors straight away from the sockets on the distributor cap.
It may be helpful to slightly twist the wires as you pull them.

Step 3

Use a 1/4" drive, 8 mm deep socket to remove the three hex bolts securing the distributor cap to the engine.
The position of the third bolt is not visible in the second picture.

Step 4

Pull the distributor cap away from the engine and set it aside.

Step 5

Use a dental pick or a small screwdriver to gently remove the D-shaped o-ring around the distributor cap flange.
Install a new o-ring in the seal recess, making sure that it is sitting flush against the flange.